How to repair and old fiberglass boat?

10
Alisha Schultz asked a question: How to repair and old fiberglass boat?
Asked By: Alisha Schultz
Date created: Mon, May 3, 2021 6:49 PM
Date updated: Wed, Jun 29, 2022 5:20 AM

Content

Video answer: Fiberglass repairs ~ fixing old holes in the hull

Fiberglass repairs ~ fixing old holes in the hull

Top best answers to the question «How to repair and old fiberglass boat»

  • Use an 80-grit sandpaper to sand the boat’s surface. Make sure that all the old paint is removed. If you are using Durabak boat paint, stick to roughing up the fiberglass surface with a 40-grit sandpaper instead. On the areas with epoxy , use a 36-grit and be a little more aggressive.

Fill any deep gouges and spend your time sanding out scratches while the filler sets up. Apply gel coat to the filled gouges and finish to the scratches and then final-sand the filled gouges. Buff all the repaired areas and then the rest of the boat. Apply any graphics to finish up.

Video answer: How to repair a badly damaged fibreglass boat

How to repair a badly damaged fibreglass boat

8 other answers

When doing fiberglass boat repairs, you’ll most likely be painting or rolling it on in small batches. The way you’ll do this is you’ll mix up a small amount of resin that you can successfully paint on over the fiberglass within about 15 to 20 minutes. This is about how much time you’ll have before the resin begins to dry and harden.

Photo 1: Remove old numbers and pinstripes to begin fiberglass repair. Set the heat gun to a low setting and peel off the old decals and numbers. Use adhesive remover to get rid of any residue. No boat spiff-up is complete without new license numbers, transom names and pinstripes.

A step by step process of how I restored a fiberglass boat console. Large holes are filled with fiberglass resin and fiberglass mat. A little filler is appl...

Tips for safely using a polisher to restore your boat's finish.

The experts at Metan Marine Restoration show how to repair a small section of damaged hull, right down to the new gelcoat application. Check out the full art...

Phone: +61 2 9533 5470Email: [email protected] Cote Marine Epoxy System is based on modern Technology and is much safer to use than most oth...

Carefully mask around the edges of the fiberglass boat repair area with two-inch-wide 3M ScotchBlue Multi-Surface Painter's Tape No. 2090. Give yourself a 16th of an inch of unmasked margin around the scratch, gouge or hole. Also, mask off any adjacent areas or items to protect them from inadvertently applied gelcoat or errant sanding.

Part 1 video will show you how to remove rust trails and 5200 sealant.Click the affiliate links below to purchase or view additional information.As an Amazon...

Your Answer

Video answer: How to boat restoration; fiberglass hole repair

How to boat restoration; fiberglass hole repair