Is it hard to replace a floor in a boat?

9
Mariane Ledner asked a question: Is it hard to replace a floor in a boat?
Asked By: Mariane Ledner
Date created: Wed, Mar 31, 2021 12:25 AM
Date updated: Sat, Jul 2, 2022 2:05 PM

Content

Top best answers to the question «Is it hard to replace a floor in a boat»

The need for a new boat floor becomes inevitable when the floor has a soft, spongy feel that is a sure sign of dry rot. However, the need for replacing a boat floor does not mean the end of your boating days. You can replace your floor in a short amount of time and with minimal labor.

8 other answers

It's very easy to put a new floor in most aluminum boats, so the down side of a low cost job not holding up long enough and needing to be done again isn't as critical as on a fiber glass boat. Cheap exterior plywood and some kind of deck or porch paint for wood will hold up for several years and just use some sand as a non skid finish.

Fiberglass boat flooring replacement is a common procedure that a lot of boat aficionados perform to restore their boats and keep them in good shape. After years of use, flooring can get damaged, particularly if left exposed to all weather conditions for a long time. Therefore, it will need replacing.

How to: Remove a Boat Floor - YouTube. TruGreen Hero Commercial (:90) Watch later. Share. Copy link. Info. Shopping. Tap to unmute. If playback doesn't begin shortly, try restarting your device.

When you install the new floor and go to put the top back on, it won't fit. Also, a very common thing to find with rotten a rotten floor is rotten stingers and wet floation foam (the older boats used open cell foam that holds water better than a sponge), and they are totally no fun to replace.

Boat floor is fiberglass & front and rear decks are carpeted over fiberglass. Structurally the floor is in bad shape, soft spots, bad cracks, etc. The stringers still feel pretty strong. Here's my thoughts: 1. Do nothing and hope i don't step through this year. 2. Can I install new plywood directly over the whole floor?

Once your wiring is complete, you can put the flooring on. We used ¾-inch treated plywood (the cheaper option), but if you really want your floor to last, opt for marine-grade plywood. (EDIT: The copper in new ACQ pressure-treated wood will corrode the aluminum stringers in a pontoon – potentially very quickly.

Pros: Without any doubt, wood is the most reliable because it is very durable if it is taken good care of and regularly maintained. Wood doesn’t need a lot of maintenance because it is very rugged. Also, there are various types of wood that can be used for boat flooring.

Making sure your boat stringers are healthy and strong is an essential part of fibreglass boat maintenance. Although it’s possible to replace small sections of the stringer, it’s often easier to make a full replacement which ensures there is no remaining damage left below the deck. To replace your stringers, follow this simple seven-step method:

Your Answer