Is jb weld good for aluminum boats?

12
Louie Cremin asked a question: Is jb weld good for aluminum boats?
Asked By: Louie Cremin
Date created: Fri, Mar 19, 2021 7:48 AM
Date updated: Sun, Aug 7, 2022 11:00 PM

Content

Top best answers to the question «Is jb weld good for aluminum boats»

J-B Weld works on aluminum, or on ANY metal surface, excepting lead. JB Weld works well on aluminum. If you think that there is an outside possibility that you might ever want to separate the parts, use a mechanical fastener… If you can't afford to do that, small holes in an aluminum boat can be fixed with epoxy putty.

J-B Weld works on aluminum, or on ANY metal surface, excepting lead. JB Weld works well on aluminum… If you can't afford to do that, small holes in an aluminum boat can be fixed with epoxy putty. The area should be hammered flat to shut the hole as much as possible.

J-B Weld works on aluminum, or on ANY metal surface, excepting lead. JB Weld works well on aluminum. If you think that there is an outside possibility that you might ever want to separate the parts, use a mechanical fastener. I like JB Weld but am now using West's Gflex thickened epoxy for repairs involving metal.

J-B MarineWeld is a specially formulated two-part epoxy cold weld system that provides for strong, lasting repairs for bonding different or similar surfaces, such as aluminum, metal, composites, fiberglass and others.

8 other answers

Best J-B Weld for Aluminum Most likely, the best JB Weld product for aluminum would be their Marine Weld option. It is designed for boats that must handle very tough conditions that most RV users do not face. You mix the 2 tubes at a 1 to 1 ratio and after application, you let it sit for 4 to 6 hours and then cure for up to 24.

This video is about how well JB Weld's Marine Weld has held up after 7 months of hard fishing. My boat still has no leaks and is a great product for your bo...

How To Fix Absolutely Anything with JB weld. If you don't have the tools to weld you can use JBweld to fix or repair anything from automotive radiators, boat...

Sadly, poor — the rod disintegrates in mere seconds, completely unable to hold together despite the JB Weld’s best efforts. It’s a fantastic material, yes – but it can’t do everything. Perhaps it...

JB Weld can take heat, I used it to attach some joints to an aluminum foundry I put together, fired by coal and forced air (later a propane/forced air burner), as I lacked a welder. It ran for an ...

JB Weld is a good product. If you repair it with JB Weld and it cracks again, you will have to have it welded for sure. Aluminum needs to be really clean to weld correctly. I would ask around and I'm sure you will find someone that works in a shop that welds and will be glad to do it for you for a small fee. If you are lucky the welder is also a fisherman. I weld for a living and I have friends that bring articles into the shop that needs welding and I am glad to do it for them, but I hate ...

I'd try JB weld, I've used it on some pretty crazy stuff. Even better would be to fabricate a couple clamp fittings and just bolt the thing together. Or you could just replace the crossbar with an ...

I figured I'd ask the question here and hopefully get some good advice on some good and maybe not so good fixes. I have acquired an aluminum boat that has a small hole in it, discovered it this past weekend when water was getting in. The hole is tiny, no more than 2 mm round. The boat has a floor in it and the hole is below floor level so I can't readily access it from the inside. I'm looking at suggestions on how to repair it. Any and all suggestions welcomed. Thanks in advance.

Your Answer