Repair vent on marine gas tank?

11
Arvid Mraz asked a question: Repair vent on marine gas tank?
Asked By: Arvid Mraz
Date created: Wed, Jun 30, 2021 12:37 PM
Date updated: Tue, Aug 16, 2022 4:37 AM

Content

Video answer: Gas tank vent line fix - 825i

Gas tank vent line fix - 825i

Top best answers to the question «Repair vent on marine gas tank»

  • Use a screwdriver to loosen the gas intake hose clamp and pull the hose from the gas tank neck. Step 2 Disconnect the fuel discharge line that goes to the fuel pump with a screwdriver. If equipped with a vent hose, unclasp the hose end or loosen the clamp with a screwdriver.
  • When your boat gas tank is not venting, this is the first area to check. If the screen looks clogged, use a small wire brush to clean away the gunk. If corrosion has eaten away at the mesh, replace the vent.

Video answer: Plastic boat gas tank leak. fixing a portable marine fuel tank

Plastic boat gas tank leak. fixing a portable marine fuel tank

9 other answers

When your boat gas tank is not venting, this is the first area to check. If the screen looks clogged, use a small wire brush to clean away the gunk. If corrosion has eaten away at the mesh, replace the vent. Watch out, through-hull fuel vents sometimes allow water intrusion. Boating Magazine.

Marine Boat Gas Tank Vent 90°Stainless Steel Marine Boat Flush Mount Fuel Gas Tank Vent for 5/8" Hose $17.94 $ 17 . 94 8% coupon applied at checkout Save 8% with coupon

When you open the vent on an expanded tank, fuel vapors will escape. If the tank is sucked in, opening the vent will allow air into the tank to equalize the pressure. For safety reasons, opening the vent should be done off the boat on a level surface with good air circulation in the area and no ignition source present, even cell phones.

How to Repair an Aluminum Fuel Tank in a Boat Step 1. Trailer the boat to a convenient work location and park the tow vehicle with the emergency brake set. Step 2. Disconnect the fuel discharge line that goes to the fuel pump with a screwdriver. If equipped with a vent hose,... Step 3. Place a ...

Close the manual vent after you have finished filling the tank. Open the vent after you connect the fuel hose and tank to your motor. If you do not open the vent, your motor will experience a vacuum lock. Remove the filler cap from the fuel tank if your motor begins to "gasp" while you are making way in your boat.

About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy & Safety How YouTube works Test new features Press Copyright Contact us Creators ...

PERKO. Replacement Gas Cap for 1270-Style Deck Fills. (2) $31.99. Compare. Skip to compare menu. ATTWOOD. Flush-Mount 316 Stainless Fuel Vents. (2)

I changed the lower unit oil on the motors put new seals on the screws and replaced one screw. All these repairs saved me close to 400$ this year, but I bought 2 new gas caps for my old tanks and the rubber seals on the caps were made with a pour grade of rubber they warped so I put the old ones back on the tanks. All in all I was happy

Locate the fuel fill hose and the vent hose access ports. As well as the fuel pick up access. Install the inflatable pipe plug into the fuel fill port and pump up to shut off the fuel fill hose. Pinch off the fuel tank vent hose. Remove the fuel hose from the pickup tube fitting and install the low-pressure air pressure gauge and hose.

Your Answer

Video answer: Plastic gas tank repair 100% fixed

Plastic gas tank repair 100% fixed